Schmidt ｜Снегоочиститель｜FS HP
Технология уборки
The clearing unit of the snow cutter-blowers consists of a two-stage snow cutter-blower system. The cutter drums are equipped with double-threaded open cutting spirals (slow-running) and feed the snow to the impeller (fast-running). The casting chute is used to achieve targeted snow ejection.
Рабочий орган
The cutter drums with the double-threaded open cutting spirals guarantee optimum snow transport to the impeller due to the cutting blades that become wider towards the inside. The outside mounted cutter drums ensure a stable hold and, in combination with the attached side cutters, very good steerability of the carrier vehicle is ensured. The cutter drums are driven via a robust central mounted bevel gear and are protected by self-readjusting clutches.
воздуходувное колесо
The optimised impeller and its geometry ensure the high clearing performance and a wide snow casting. The ejection distance depends on the speed of the blower wheel, i.e. the PTO speed or the amount of hydraulic oil supplied by the carrier vehicle.
Патрубок
Снегоочиститель FS HP оборудован патрубком с гидроприводом поворота для погрузки снега на платформу автомобиля. Угол поворота патрубка составляет 275°, дальность выброса снега в сторону – до 35 м. Снег формирует в патрубке компактный поток. Гидравлические клапаны позволяют изменять дальность выброса снега, а поворотный патрубок – направление. Снег можно отбрасывать в сторону или грузить на платформу автомобиля.
Вал фрезерного барабана
To ensure that the snow cutter-blowers withstand the high loads, forces and wear, the components are made of highly wear-resistant materials. The lateral snow blades are integrated and capture/cut the snow. The ground clearance can be defined using sliding shoes or optional castor wheels. The screwed-on side deflectors serve as collision protection.
Система привода
Depending on the carrier vehicle, the power supply is either mechanical, provided by the PTO and a gearbox or via the power hydraulics.
Варианты крепления / монтажа
The snow cutter-blowers can be equipped with the following attachments/devices, which include hydraulic slope compensation:
- Attachment device including lifting device and mounting plate according to EN, DIN or VSS.
- Attachment devices for wheel loaders
- Three-point linkage of categories II and III
Опции
- Система гидравлической компенсации продольного наклона.
- *Парковочная тележка.
- Светодиодные маркерные огни с функцией наклона
- Устройство защиты при транспортировке.